Toro Groundsmaster 4500-D Service Manual page 272
Hide thumbs
Also See for Groundsmaster 4500-D:
- Service manual (474 pages) ,
- Operator's manual (92 pages) ,
- Installation instructions manual (28 pages)
Table of Contents
Advertisement
Installation
1. Coat new shaft seal with grease and install in axle
case as shown (Fig. 25).
2. Install the lower bevel gear and bevel gear shaft in
the axle case cover. Coat a new O-ring with grease and
install the axle case cover (Fig. 26). Tighten cover
screws from 17 to 20 ft-lb (23 to 27 N- -m).
3. Slide the bevel gear case over the bevel gear shaft
and install the bevel gear and collar. Make sure the bevel
gear shaft is completely seated in the upper and lower
bearings (Fig. 26).
4. Install the knuckle pin. Use medium strength thread--
locking compound and tighten the knuckle pin mounting
screws from 17 to 20 ft-lb (23 to 27 N- -m).
Axles, Planetaries and Brakes
2
1
1. Axle case
2. Bevel gear case
8
6
5
2
4
1. Axle case cover
2. Lower bevel gear
3. Bevel gear shaft
4. Lower bearing
Page 6 - - 26
3
Figure 25
3. Shaft seal
7
Figure 26
5. Upper bevel gear
6. Collar
7. Upper bearing
8. Knuckle pin
Groundsmaster 4500--D/4700--D
3
1
- Quick Links:
- Fault Codes
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
