Toro Groundsmaster 4500-D Service Manual page 120
Hide thumbs
Also See for Groundsmaster 4500-D:
- Service manual (474 pages) ,
- Operator's manual (92 pages) ,
- Installation instructions manual (28 pages)
Table of Contents
Advertisement
5. Remove caps and plugs from hydraulic lines and fit-
tings. Install hydraulic lines to gear pump (see Hydraulic
Hose and Tube Installation in the General Information
section of this chapter).
6. Replace hydraulic oil filter and fill hydraulic reservoir
with new hydraulic oil.
7. Fill piston pump housing through case drain (90
barbed fitting) with new hydraulic oil (Fig. 65). This will
ensure that internal pump components have adequate
lubrication during initial operation.
Hydraulic System
8. Prime hydraulic pumps (see Priming Hydraulic
Pumps in this section).
9. Properly fill hydraulic system (see Charge Hydraulic
System in this section).
10.Stop engine and check for hydraulic oil leaks. Check
hydraulic reservoir oil level and adjust if necessary.
o
Page 4 - - 80
Groundsmaster 4500--D/4700--D
- Quick Links:
- Fault Codes
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
