Toro Groundsmaster 4500-D Service Manual page 201
Hide thumbs
Also See for Groundsmaster 4500-D:
- Service manual (474 pages) ,
- Operator's manual (92 pages) ,
- Installation instructions manual (28 pages)
Table of Contents
Advertisement
Main Information Screens
The two (2) InfoCenter main information screens (Figs.
10 and 11) are displayed after the initial splash screens
have been displayed for several seconds. During nor-
mal machine operation, the main information screens
provide machine information for the operator. Toggling
between the main information screens is done by press-
ing the right button on the InfoCenter.
The main information screens can be used to monitor
engine coolant temperature, hydraulic oil temperature,
battery voltage, engine RPM and traction speed range.
The screens will also identify if the parking brake is ap-
plied or if the PTO is engaged.
The main information screens will display arrows
whenever the cutting decks are either raising (up ar-
rows) or lowering (down arrows).
If controls are not selected properly to allow certain ma-
chine operations, an advisory will be displayed on the
InfoCenter Display. Typically, an advisory can be elimin-
ated with a change in controls by the operator.
If an electrical machine fault occurs during machine op-
eration, the InfoCenter fault indicator will blink to notify
the operator. Accessing the fault log is described below
in Faults Screen.
If an electrical engine fault occurs during machine op-
eration, the fault will be displayed on the InfoCenter to
notify the operator. The engine fault will be retained in
the engine electronic control unit (ECU) and can be
viewed using the engine diagnostic tool. Engine faults
are not stored in the TEC controller so they cannot be
viewed using the InfoCenter Faults Screen.
The main menu and additional information screens can
be accessed from the InfoCenter main information
screen by pressing and releasing the menu/back button
(left button) on the display. Information on the main
menu and menu item screens is included below.
Groundsmaster 4500--D/4700--D
4
3
100
2
1
7
1. Parking brake applied
2. Traction speed
3. Coolant temperature
4. Fault indicator
3
2
140
1
8
1. Battery voltage
2. Hydraulic oil temperature
3. Fault indicator
4. Time to next service
Page 5 - - 9
170
T
240
L
P
6
5
Figure 10
5. Right button
6. Down button
7. Menu/back button
180
T
220
Service due
in 155 Hours
13.2V
RPM
1250
6
7
Figure 11
5. Engine RPM
6. Right button
7. Down button
8. Menu/back button
Electrical System
4
5
- Quick Links:
- Fault Codes
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
