Converting A New Phone From Sccp To Sip; Converting An In-Use Phone From Sccp To Sip; Converting An In-Use Phone From Sip To Sccp - Cisco 7962G Administration Manual
For cisco unified communications manager 6.0
Hide thumbs
Also See for 7962G:
- Administration manual (235 pages) ,
- User manual (110 pages) ,
- Specifications (5 pages)
Table of Contents
Advertisement
Using Cisco Unified IP Phones with Different Protocols
Converting a New Phone from SCCP to SIP
A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:
Procedure
Step 1
Take one of these actions:
•
•
•
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about
Cisco Unified Communications Manager configuration. Refer to Cisco Unified Communications
Manager Bulk Administration Guide for detailed information about using the BAT.
If you are not using DHCP in your network, configure the network parameters for the phone.
Step 2
See the "Configuring Startup Network Settings" section on page 3-14.
Power cycle the phone.
Step 3
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use in your network from
SCCP to SIP. To access BAT from Cisco Unified Communications Manager Administration, choose
Bulk Administration > Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to
Cisco Unified Communications Manager Bulk Administration Guide.
Converting an In-Use Phone from SIP to SCCP
To convert a phone that is in use in your network from SIP to SCCP, perform these steps. For more
information, Cisco Unified Communications Manager Administration Guide.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, delete the existing SIP phone from the
Cisco Unified Communications Manager database.
Step 2
In Cisco Unified Communications Manager Administration, create the phone as an SCCP phone.
Step 3
Power cycle the phone.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.0
2-12
To auto-register the phone, set the Auto Registration Phone Protocol parameter in Cisco Unified
Communications Manager Administration to SIP.
To provision the phone using the Bulk Administration Tool (BAT), choose the appropriate phone
model and choose SIP from the BAT.
To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration
page in Cisco Unified Communications Manager Administration.
Chapter 2
Preparing to Install the Cisco Unified IP Phone on Your Network
OL-12641-01
Advertisement
Table of Contents
Troubleshooting
