Verifying The Phone Startup Process - Cisco 7962G Administration Manual
For cisco unified communications manager 6.0
Hide thumbs
Also See for 7962G:
- Administration manual (235 pages) ,
- User manual (110 pages) ,
- Specifications (5 pages)
Table of Contents
Advertisement
Verifying the Phone Startup Process
Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand.
Step 3
The keyholes fit standard phone jack mounts.
Hang the phone on the wall.
Step 4
Figure 3-3
1
2
3
Verifying the Phone Startup Process
After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by
cycling through the following steps.
1.
2.
If the line keys flash red in sequence after flashing amber, do not power down the phone until the
Caution
sequence of red flashes completes. This sequence can take several minutes to complete.
3.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.0
3-12
Parts Used in Wall Mounting the Cisco Unified IP Phone
Footstand adjustment button—Raises and lowers adjustment plate
Wall mounting screw holes
Adjustment plate—Raises and lowers phone vertically
These buttons flash on and off in sequence:
Headset (only of the handset is off-hook when the phone powers up. Hang up the handset within
–
3 seconds to have the phone launch its secondary load. To continue with the primary load, leave
the handset off-hook.)
Mute
–
Speaker
–
Some or all of the line keys flash amber in sequence.
Some or all of the line keys flash green.
Chapter 3
AUX
Setting Up the Cisco Unified IP Phone
OL-12641-01
Advertisement
Table of Contents
Troubleshooting
