Using Cisco Unified Ip Phones With Different Protocols; Converting A New Phone From Sccp To Sip; Converting An In-Use Phone From Sccp To Sip - Cisco 7975G Software Manual
Administration guide for cisco unified communications manager 7.0 (sccp and sip)
Hide thumbs
Also See for 7975G:
- Software manual (302 pages) ,
- Administration manual (217 pages) ,
- Troubleshooting and maintenance (25 pages)
Table of Contents
Advertisement
Using Cisco Unified IP Phones with Different Protocols
Using Cisco Unified IP Phones with Different Protocols
The Cisco Unified IP Phone can operate with SCCP (Skinny Client Control Protocol) or SIP (Session
Initiation Protocol). You can convert a phone that is using one protocol for use with the other protocol.
This section includes these topics:
•
•
•
•
Converting a New Phone from SCCP to SIP
A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:
Procedure
Take one of these actions:
Step 1
•
•
•
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about
Cisco Unified Communications Manager configuration. Refer to Cisco Unified Communications
Manager Bulk Administration Guide for detailed information about using BAT.
Step 2
If you are not using DHCP in your network, configure the network parameters for the phone.
See the "Configuring Startup Network Settings" section on page 3-14.
Power cycle the phone.
Step 3
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use in your network from
SCCP to SIP. To access BAT from Cisco Unified Communications Manager Administration, choose
Bulk Administration > Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to
Cisco Unified Communications Manager Bulk Administration Guide.
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
2-12
Converting a New Phone from SCCP to SIP, page 2-12
Converting an In-Use Phone from SCCP to SIP, page 2-12
Converting an In-Use Phone from SIP to SCCP, page 2-13
Deploying a Phone in an SCCP and SIP Environment, page 2-13
To auto-register the phone, set the Auto Registration Phone Protocol enterprise parameter in
Cisco Unified Communications Manager Administration to SIP.
To provision the phone by using the Bulk Administration Tool (BAT), choose the appropriate phone
model and choose SIP from BAT.
To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration
window in Cisco Unified Communications Manager Administration.
Chapter 2
Preparing to Install the Cisco Unified IP Phone on Your Network
OL-15790-01
Advertisement
Table of Contents
Troubleshooting
