Adding Phones With Auto-Registration - Cisco 7975G Software Manual
Administration guide for cisco unified communications manager 7.0 (sccp and sip)
Hide thumbs
Also See for 7975G:
- Software manual (302 pages) ,
- Administration manual (217 pages) ,
- Troubleshooting and maintenance (25 pages)
Table of Contents
Advertisement
Chapter 2
Preparing to Install the Cisco Unified IP Phone on Your Network
Table 2-5
Communications Manager database.
Table 2-5
Method
Auto-registration
Auto-registration with
TAPS
Using the Cisco Unified
Communications
Manager Administration
Using BAT
Adding Phones with Auto-Registration
By enabling auto-registration before you begin installing phones, you can:
•
•
•
•
Cisco recommends you use auto-registration to add less than 100 phones to your network. To add more
Note
than 100 phones to your network, use the Bulk Administration Tool (BAT). See the
with BAT" section on page
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
OL-15790-01
provides an overview of these methods for adding phones to the Cisco Unified
Methods for Adding Phones to the Cisco Unified Communications Manager
Database
Requires MAC
Address?
No
No
Yes
Yes
Add phones without first gathering MAC addresses from the phones.
Automatically add a Cisco Unified IP Phone to the Cisco Unified Communications Manager
database when you physically connect the phone to your IP telephony network. During
auto-registration, Cisco Unified Communications Manager assigns the next available sequential
directory number to the phone.
Quickly enter phones into the Cisco Unified Communications Manager database and modify any
settings, such as the directory numbers, from Cisco Unified Communications Manager.
Move auto-registered phones to new locations and assign them to different device pools without
affecting their directory numbers.
2-11.
Adding Phones to the Cisco Unified Communications Manager Database
Notes
Results in automatic assignment of directory
•
numbers.
Not available when security or encryption is
•
enabled.
Requires auto-registration and the Bulk
Administration Tool (BAT); updates the Cisco
Unified Communications Manager database with
the MAC address and DNs for the device when user
calls TAPS from the phone.
Requires phones to be added individually
Can add groups of same model of phone.
Can schedule when phones are added to the Cisco
Unified Communications Manager database.
"Adding Phones
2-9
Advertisement
Table of Contents
Troubleshooting
