Adding Phones With Auto-Registration And Taps - Cisco 7975G Software Manual
Administration guide for cisco unified communications manager 7.0 (sccp and sip)
Hide thumbs
Also See for 7975G:
- Software manual (302 pages) ,
- Administration manual (217 pages) ,
- Troubleshooting and maintenance (25 pages)
Table of Contents
Advertisement
Adding Phones to the Cisco Unified Communications Manager Database
Auto-registration is disabled by default. In some cases, you might not want to use auto-registration; for
example, if you want to assign a specific directory number to the phone, or if you plan to implement
authentication or encryption, as described in Cisco Unified Communications Manager Security Guide.
For information about enabling auto-registration, refer to "Enabling Auto-Registration" in the Cisco
Unified Communications Manager Administration Guide.
When you configure the cluster for mixed mode through the Cisco CTL client, auto-registration is
Note
automatically disabled. When you configure the cluster for non-secure mode through the Cisco CTL
client, auto-registration is automatically enabled.
Related Topics
•
•
•
Adding Phones with Auto-Registration and TAPS
You can add phones with auto-registration and TAPS, the Tool for Auto-Registered Phones Support,
without first gathering MAC addresses from phones.
TAPS works with the Bulk Administration Tool (BAT) to update a batch of phones that were already
added to the Cisco Unified Communications Manager database with dummy MAC addresses. Use TAPS
to update MAC addresses and download pre-defined configurations for phones.
Note
Cisco recommends you use auto-registration and TAPS to add less than 100 phones to your network. To
add more than 100 phones to your network, use the Bulk Administration Tool (BAT). See the
Phones with BAT" section on page
To implement TAPS, you or the end-user dial a TAPS directory number and follow voice prompts. When
the process is complete, the phone will have downloaded its directory number and other settings, and the
phone will be updated in Cisco Unified Communications Manager Administration with the correct MAC
address.
Auto-registration must be enabled in Cisco Unified Communications Manager Administration
(System > Cisco Unified CM) for TAPS to function.
When you configure the cluster for mixed mode through the Cisco CTL client, auto-registration is
Note
automatically disabled. When you configure the cluster for non-secure mode through the Cisco CTL
client, auto-registration is automatically enabled.
Refer to Cisco Unified Communications Manager Bulk Administration Guide for detailed instructions
about BAT and about TAPS.
Related Topics
•
•
•
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
2-10
Adding Phones with Auto-Registration and TAPS, page 2-10
Adding Phones with Cisco Unified Communications Manager Administration, page 2-11
Adding Phones with BAT, page 2-11
Adding Phones with Auto-Registration, page 2-9
Adding Phones with Cisco Unified Communications Manager Administration, page 2-11
Adding Phones with BAT, page 2-11
Chapter 2
Preparing to Install the Cisco Unified IP Phone on Your Network
2-11.
"Adding
OL-15790-01
Advertisement
Table of Contents
Troubleshooting
