Adding Phones With Auto-Registration And Taps - Cisco 7961G Administration Manual
For cisco callmanager 4.1(3)
Hide thumbs
Also See for 7961G:
- Administration manual (260 pages) ,
- Phone manual (92 pages) ,
- Datasheet (8 pages)
Table of Contents
Advertisement
Chapter 2
Preparing to Install the Cisco IP Phone on Your Network
Note
Adding Phones with Auto-Registration and TAPS
Note
Cisco IP Phone Administration Guide for Cisco CallManager, Cisco IP Phone 7961G/7961G-GE and 7941G/7941G-GE
OL-6966-01
Auto-registration is disabled by default.
For information about enabling and configuring auto-registration, refer to the
Cisco CallManager Administration Guide.
When you configure the cluster for mixed mode through the Cisco CTL client,
auto-registration is automatically disabled. When you configure the cluster for
non-secure mode through the Cisco CTL client, auto-registration is automatically
enabled.
Related Topics
Adding Phones with Auto-Registration and TAPS, page 2-13
•
Adding Phones with Cisco CallManager Administration, page 2-14
•
Adding Phones with BAT, page 2-15
•
You can add phones with auto-registration and TAPS without first gathering
MAC addresses from phones.
Cisco recommends you use auto-registration and TAPS to add less than 100
phones to your network. To add more than 100 phones to your network, use the
Bulk Administration Tool (BAT).
TAPS, the Tool for Auto-Registered Phones Support, works with the Bulk
Administration Tool (BAT) to update phones that were already added to the
Cisco CallManager database with dummy MAC addresses. Use TAPS to update
MAC addresses and download pre-defined configurations for phones.
To implement TAPS, you or the end-user dial a TAPS directory number and
follow voice prompts. When the process is complete, the phone will have
downloaded its directory number and other settings, and the phone will be
updated in Cisco CallManager Administration with the correct MAC address.
You must make sure that Auto-registration is enabled in Cisco CallManager
Administration (System > Cisco CallManager) for TAPS to function.
Adding Phones to the Cisco CallManager Database
2-13
Advertisement
Chapters
Table of Contents
Troubleshooting
