Configuring Remote Management - Cisco CVR100W Administration Manual
Wireless-n 300m router
Hide thumbs
Also See for CVR100W:
- Administration manual (150 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
Administering Your CVR100W
Configuring Remote Management
Configuring Remote Management
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Cisco CVR100W Wireless-N 300M Router Administration Guide
You can access the web-based Device Manager from the LAN side by using the
CVR100W's LAN IP address and HTTPS (HTTP over SSL) or HTTP, or from the
WAN side by using the CVR100W's WAN IP address and HTTPS or HTTP.
To configure remote management:
Choose Administration > Remote Management.
In the Web Access field, select the way that you access the web-based Device
Manager from a local PC.
•
HTTP: Check to allow you to access the web-based Device Manager from
the LAN side by using the CVR100W's LAN IP address and HTTP.
•
HTTPS: Check to allow you to access the web-based Device Manager from
the LAN side by using the CVR100W's LAN IP address and HTTPS.
In the Remote Management field, check Enable to enable remote management.
Enabling this feature allows you to remotely manage the CVR100W from the WAN
side by using the CVR100W's WAN IP address.
In the Remote Access field, select the way that you access the web-based
Device Manager from a remote WAN network.
•
HTTP: Check to allow you to access the web-based Device Manager from
a remote WAN network by using the CVR100W's WAN IP address and HTTP.
•
HTTPS: Check to allow you to access the web-based Device Manager from
a remote WAN network by using the CVR100W's WAN IP address and
HTTPS.
In the Remote Upgrade field, check Enable to allow you to upgrade the firmware
remotely.
In the Allowed Remote IP Address field, click the Any IP Address radio button to
allow any IP address from a remote WAN network to access the CVR100W, or
enter a range of IP addresses in the address field to restrict remote access to the
hosts in the specified remote network.
In the Remote Management Port field, enter the port number for remote
management. The default value is 8080.
Click Save.
7
93
Advertisement
Table of Contents
