Configuring Ipv6 Lan Settings; Setting The Ip Mode - Cisco CVR100W Administration Manual
Wireless-n 300m router
Hide thumbs
Also See for CVR100W:
- Administration manual (150 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
Configuring Network
Configuring IPv6
STEP 4
Cisco CVR100W Wireless-N 300M Router Administration Guide
IPv6 Address
IPv6 Prefix Length
Default IPv6
Gateway
Static DNS 1
Static DNS 2
Click Save.
Configuring IPv6 LAN Settings
In the IPv6 mode, the LAN DHCP server is enabled by default (similar to the IPv4
mode). The DHCPv6 server assigns IPv6 addresses from configured address
pools that use the IPv6 prefix length assigned to the LAN.
Setting the IP Mode
To configure IPv6 LAN settings on your CVR100W, you must first set the IP mode
to one of the following modes:
•
LAN:IPv6, WAN:IPv4
•
LAN:IPv6, WAN:IPv6
•
LAN:IPv4+IPv6, WAN:IPv4
•
LAN:IPv4+IPv6, WAN:IPv4+IPv6
Enter the IPv6 address of the WAN port.
Enter the IPv6 prefix length defined by the ISP.
The IPv6 network (subnet) is identified by the initial
bits of the address which are called the prefix.
For example, in the 2001:0DB8:AC10:FE01::
IP address, 2001 is the prefix.
All hosts in the network have identical initial bits for
their IPv6 address; you set the number of common
initial bits in the network's addresses in this field.
Enter the IPv6 address of the default gateway. This is
the IP address of the server at the ISP that this router
connects to for accessing the Internet.
Enter the IP address of the primary DNS server on the
ISP's IPv6 network.
Enter the IP address of the secondary DNS server on
the ISP's IPv6 network.
2
41
Advertisement
Table of Contents
