Cisco MDS 9124 - Fabric Switch Reference page 1022
Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)
Hide thumbs
Also See for Cisco MDS 9124 - Fabric Switch:
- Datasheet (9 pages) ,
- Specifications (3 pages) ,
- Command reference manual (1640 pages)
Table of Contents
Advertisement
system health module
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch(config)# system health module 6 bootflash failure-action
System health failure action for module 6 Bootflash test is already enabled.
The following example disables the bootflash test configuration.
switch(config)# no system health module 6 bootflash failure-action
System health failure action for module 6 Bootflash test is now disabled.
The following example sets the new frequency of the bootflash test to 200 seconds.
switch(config)# system health module 6 bootflash frequency 200
The new frequency is set at 200 Seconds.
The following example enables the EOBC test.
switch(config)# system health module 6 eobc
System health for module 6 EOBC is now enabled.
The following example enables the inband test.
switch(config)# system health module 6 inband
System health for module 6 EOBC is now enabled.
The following example enables the loopback test.
switch(config)# system health module 6 loopback
System health for module 6 EOBC is now enabled.
The following example enables the management test.
switch(config)# system health module 6 management
System health for module 6 EOBC is now enabled.
The following example shows how to set the CompactFlash CRC test interval.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module 6 cf-crc-check frequency 10
The following example shows how to set the CompactFlash CRC test failure-action feature.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module 6 cf-crc-check failure-action
The following example shows how to set the CompactFlash reflash update interval.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module 6 cf-reflash frequency 10
The following example shows how to set the CompactFlash reflash failure-action feature.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module # cf-re-flash failure-action
Related Commands
Command
show system health
show system health
statistics
Cisco MDS 9000 Family Command Reference
21-104
Description
Displays system health information.
Displays system health statistics.
Chapter 21
OL-16217-01, Cisco MDS SAN-OS Release 3.x
S Commands
Advertisement
Table of Contents
