show ipv6 traffic
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show ipv6 traffic
To display IPv6 protocol statistics for the system, use the show ipv6 traffic command.
Syntax Description
interface
gigabitethernet slot/port Displays a Gigabit Ethernet interface slot and port number.
mgmt 0
port-channel number
vsan vsan-id
Defaults
None.
Command Modes
EXEC mode.
Command History
Release
3.1(0)
Usage Guidelines
None.
Examples
The following example displays IPv6 protocol statistics on the system.
switch# show ipv6 traffic
IPv6 Statistics:
Rcvd:
Sent:
ICMPv6 Statistics:
Rcvd:
Sent:
Cisco MDS 9000 Family Command Reference
22-180
show ipv6 traffic [interface {gigabitethernet slot/port | mgmt 0 | port-channel number | vsan
vsan-id}]
Displays the IP interface status and configuration.
Displays the management interface.
Dispalsy the PortChannel interface. The range is 1 to 256.
Displays a IPFC VSAN interface and specifies the VSAN ID. The range is
1 to 4093.
Modification
This command was introduced.
1 total, 0 local destination
0 errors, 0 truncated, 0 too big
0 unknown protocol, 0 dropped
0 fragments, 0 reassembled
0 couldn't reassemble, 0 reassembly timeouts
0 generated, 0 forwarded 0 dropped
0 fragmented, 0 fragments created, 0 couldn't fragment
0 total, 0 errors, 0 unreachables, 0 time exceeded
0 too big, 0 param probs, 0 admin prohibs
0 echos, 0 echo reply, 0 redirects
0 group query, 0 group report, 0 group reduce
0 router solicit, 0 router advert
0 neighbor solicit, 0 neighbor advert
74 total, 0 errors, 0 unreachables, 0 time exceeded
0 too big, 0 param probs, 0 admin prohibs
0 echos, 0 echo reply, 0 redirects
0 group query, 53 group report, 0 group reduce
Chapter 22
Show Commands
OL-16217-01, Cisco MDS SAN-OS Release 3.x