hit counter script

Tcp Max-Jitter - Cisco MDS 9124 - Fabric Switch Reference

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)
Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:
Table of Contents

Advertisement

tcp max-jitter

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
tcp max-jitter
To estimate the maximum delay jitter experienced by the sender in microseconds, use the tcp max-jitter
command. Use the no form of this command to disable this feature or revert to its factory defaults.
Syntax Description
microseconds
Defaults
Enabled.
The default value is 100 microseconds for FCIP and 500 microseconds for iSCSI interfaces.
Command Modes
FCIP profile configuration submode.
Command History
Release
1.3(4)
Usage Guidelines
None.
Examples
The following example configures delay jitter time:
switch# config terminal
Enter configuration commands, one per line.
switch(config)# fcip profile 3
switch(config-profile)# tcp max-jitter 600
switch(config-profile)# do show fcip profile 3
FCIP Profile 3
Cisco MDS 9000 Family Command Reference
23-32
tcp max-jitter microseconds
no tcp max-jitter microseconds
Modification
This command was introduced.
Internet Address is 10.3.3.3
Tunnels Using this Profile: fcip3
Listen Port is 3225
TCP parameters
SACK is enabled
PMTU discovery is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 200 ms
Maximum number of re-transmissions is 4
Send buffer size is 0 KB
Maximum allowed bandwidth is 1000000 kbps
Minimum available bandwidth is 500000 kbps
Estimated round trip time is 1000 usec
Congestion window monitoring is enabled, burst size is 10 KB
Configured maximum jitter is 600 us
Specifies the delay time in microseconds ranging from 0 to 10000.
End with CNTL/Z.
(interface GigabitEthernet2/3)
Chapter 23
OL-16217-01, Cisco MDS SAN-OS Release 3.x
T Commands

Advertisement

Table of Contents
loading

Table of Contents