Show Module - Cisco MDS 9124 - Fabric Switch Reference

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)

Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:

Table of Contents

Show Commands

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show module

To verify the status of a module, use the show module command.

Syntax Description

recovery-steps

Command Modes

Command History

Usage Guidelines

If your chassis has more than one switching module, you will see the progress check if you issue the

show module command several times and view the status column each time.

The switching module goes through a testing and an initializing stage before displaying an

Use the uptime option to display the time that a specified supervisor module, switching module, or

services module is functional in the switch. This time is computed from the time a module goes online

after a disruptive upgrade or reset.

You can use the recovery-steps option only for modules that are powered down because of problems

with index allocation.

Before using the recovery-steps option, make sure that debug module no-power-down is not on.

You cannot use the recovery-steps option to recover a Supervisor module. Also, the Cisco MDS 9124

switch does not support the recovery-steps option.

For additional information about port indices, refer to the Cisco MDS 9000 Family CLI Configuration

Guide and to the Cisco MDS 9000 Family Troubleshooting Guide.

The following example displays information about the modules on the switch.

switch# show module

OL-16217-01, Cisco MDS SAN-OS Release 3.x

show module [slot [recovery-steps] | diag | uptime | xbar number]

Specifies the slot number for the module.

Displays information about modules and the steps to recover a module.

Displays module-related information.

Displays the length of time that the modules have been functional in the

Displays information about the specified crossbar, either 1 or 2.

Modification

This command was introduced.

Added the recovery-steps and xbar options.

Cisco MDS 9000 Family Command Reference