Cisco MDS 9124 - Fabric Switch Reference page 1387

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)

Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:

Table of Contents

Show Commands

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Not Configured

The following example displays the loopback test time log for all modules.

switch# show system health statistics loopback timelog

-----------------------------------------------------------------

-----------------------------------------------------------------

The following example displays the loopback test statistics for a specified module.

switch# show system health statistics loopback module 8 timelog

-----------------------------------------------------------------

-----------------------------------------------------------------

OL-16217-01, Cisco MDS SAN-OS Release 3.x

describes the status value for each module

Shows the Status Value for Each Module

Interface-specific counters will remain at zero unless the module-specific loopback test reports

errors or failures.

OHMS test is running and there are no errors

OHMS test has started to fail or in the process of

OHMS test failed.

OHMS test stopped. This is a transient state (for

example, during upgrades and downgrades).

OHMS test process or thread exited while running

OHMS test configured to not run on the module.

OHMS test failed because of internal failure.

OHMS test failed in performing diagnostics.

OHMS test suspended because of too many error

conditions. OHMS cannot complete the test to

determine the hardware status.

OHMS test is halted because the test is not

intended to run on the module. (for example, a

specific hardware of which a test is operating is

not found on the module).

OHMS is disabled by the user but not the test.

OHMS test is disabled by the user.

Cisco MDS 9000 Family Command Reference

show system health