Specifying The Sip Subslot Location For A Spa; Shared Port Adapters - Cisco SCE8000 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for SCE8000:
- Configuration manual (262 pages) ,
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages)
Table of Contents
Advertisement
Chapter 2
Introduction to the Cisco SCE8000 Platform
Specifying the SIP Subslot Location for a SPA
Cisco SCE8000-SIP subslots begin their numbering with "0" and have a horizontal orientation.
Figure 2-3
The Cisco SCE8000-SIP supports four subslots for the installation of SPAs, as follows:
•
•
•
•
Figure 2-3
Shared Port Adapters
The SPA supported by the Cisco SCE8000-SIP is the 1-Port 10-Gigabit Ethernet SPA,
SPA-1X10GE-L-V2
The following list describes some of the general characteristics of a SPA:
•
•
Figure 2-4
Single-height SPA
Single-height SPA
•
•
OL-16478-03
shows the subslot numbering for the Cisco SCE8000-SIP.
SIP subslot 0—Top–left subslot
SIP subslot 1—Top–right subslot
SIP subslot 2—Bottom–left subslot
SIP subslot 3—Bottom–right subslot
SPA Module Subslot Location
Front of SCE8000-SIP
Sub-slot 0
Sub-slot 1
Sub-slot 2
Sub-slot 3
A SPA is a modular type of port adapter that inserts into a subslot of a compatible SIP carrier card
to provide network connectivity and increased interface port density. The Cisco SCE8000-SIP can
hold up to four SPAs.
Since the interfaces are connected in subscriber/network pairs, either two or four SPAs must be
installed.
The supported SPA is a single-height SPAs, which inserts into one SIP subslot. (See
Single-Height SPA Size
Front of the SCE8000-SIP
Single-height SPA
Single-height SPA
Each SPA provides a one 10GBE port, which is the interface to either subscriber or network traffic.
These interfaces can be individually configured using the Cisco command-line interface (CLI).
Either a blank filler plate or a functional SPA should reside in every subslot of an SIP during normal
operation to maintain cooling integrity. Blank filler plates are available in single-height form only.
Since the interfaces are connected in subscriber/network pairs, the SCE8000-SIP must be either
fully populated or have both the bottom bays covered with blank filler plates.
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
Introduction to SIPs and SPAs
Figure
2-4.)
2-5
Advertisement
Table of Contents
Troubleshooting
