Using Optical Splitters With 10Gbe Links; Supported Configurations - Cisco SCE8000 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for SCE8000:
- Configuration manual (262 pages) ,
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages)
Table of Contents
Advertisement
Using Optical Splitters with 10GBE Links
•
•
When designing a deployment with the SCE8000, it is important to keep in mind certain characteristics
of the 10GBE link that affect the configuration of optical splitters and SPAN ports.
•
•
•
Supported Configurations
Due to the 10GBE characterstics described above, the following configurations are supported in the 10
GBE environment.
Figure A-1
Subscriber
OL-16478-03
Supported Configurations, page A-1
Unsupported Configuration, page A-2
Ten Gigabit Ethernet does not support autonegotiation (unlike regular GBE). The fixed 10GBE
configuration is as follows:
duplex = full
–
speed = 10 GBE
–
The 10GBE port is UP once it detects light (and correct sync pattern) in the RX input.
A Switch or Router port will not transmit data unless it is UP (that is, it detects a good signal on the
RX input).
Supported Optical Splitter Configuration
Switch
A P P E N D I X
Router
Splitter
RX TX
RX TX
3/0/0
3/1/0
3/2/0
3/3/0
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
A
Network
A-1
Advertisement
Table of Contents
Troubleshooting
