Removing and Replacing Modules
Figure 9-13
FA N ST
SC E8 00
Tighten the two captive installation screws on the module.
Step 11
Make sure the ejector levers are fully closed before tightening the captive installation screws.
Note
Removing a Module
Before you remove an SCE8000-SCM, you should first save the current configuration, if the current
configuration should be preserved and duplicated on the new SCE8000-SCM-E. (Use the copy
running-config startup-config command.) This step saves time when bringing the module back online,
if the configuration will remain the same or similar. You can recover the configuration by downloading
it from the server to the nonvolatile memory of the SCE8000-SCM-E.
When you install a new SCE8000-SCM-E, check the factory default configuration; you might need to
Tip
reconfigure the system to your requirements. You can reconfigure the SCE8000-SCM-E manually, or if
you previously uploaded the original configuration to a server, you can download it to the new
SCE8000-SCM-E.
Step 1
At the SCE# prompt, type reload shutdown and press Enter to power down the Cisco SCE8000
platform before installing or removing any module.
Step 2
Verify that the captive installation screws on all of the modules in the chassis are tight. This step assures
that the space created by the removed module is maintained.
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
9-18
Ejector Lever Closure
SCE 8000
-SCM -E
AT US
1
SC M
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
STA TUS
LINK
1000
OPT ICA
ACTI VE
L BYP ASS
SCE 8000
-SCM -E
SC M
2
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
STA TUS
LINK
1000
OPT ICA
ACTI VE
L BYP ASS
SCE 8000
-SIP
3
SIP
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
4
TX
TX
0- FA N
TX
A C
RX
TX
B
CT RL
RX
D
A B
RX
C
RX
D
STA TU
OP TIC AL
S
BY PA SS
OP B-S
1
CE 8K -M
M
Ejector levers flush
with module faceplate
Chapter 9
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
Removal and Replacement Procedures
OL-16478-03