Table of Contents
Advertisement
Checking the LEDs
Step 4
Step 5
Note
Checking the LEDs
Removing or Replacing a Content Engine
Warning
Warning
Cisco Content Engine 511 and 566 Hardware Installation Guide
3-14
Download from Www.Somanuals.com. All Manuals Search And Download.
Power up all externally connected devices.
Press the power control button on the front of the Content Engine.
The system should begin booting. Once the operating system boots, you are ready
to initialize the basic software configuration. (Refer to the software configuration
guide or user guide that shipped with your system.)
While the Content Engine is powering up, the green power on LED on the
Note
front of the Content Engine is on.
You can install a circular disk over the power control button to prevent accidental
manual power down. This disk, known as the power control button shield, comes
with the Content Engine.
When the Content Engine is up and running, observe the front panel LEDs.
(See the
"LED Indicators" section on page 1-8
operating properly.)
Before working on a system that has an on/off switch, turn OFF the power and
unplug the power cord. Statement 1
Ultimate disposal of this product should be handled according to all national
laws and regulations. Statement 1040
Chapter 3
Installing the Content Engine
to verify that your system is
OL-5756-01
Advertisement
Table of Contents
Troubleshooting
