Table of Contents
Advertisement
Chapter 4
Installing Hardware Options
Hardware Problems
System Configuration Problems
Fibre Channel Problems
OL-5756-01
Download from Www.Somanuals.com. All Manuals Search And Download.
Take the following actions to determine if your installation problem is caused by
the hardware:
Verify that all adapters are installed securely.
1.
Verify that all cables are attached securely to the correct connectors. Be sure
2.
that one end of the LC-LC Fibre Channel cable is attached to the optical
interface connector and that the other end is connected to the Fibre Channel
device.
Verify that the Fibre Channel adapter is installed correctly and is fully seated
3.
in the correct expansion slot.
Verify that all peripheral devices are turned on.
4.
Verify that the Fibre Channel adapter card is installed in the correct PCI-X slot. If
you still have a system configuration problem, contact Cisco technical support for
assistance. (See the
"Obtaining Technical Assistance" section on page
To determine if your installation problem is caused by an attached Fibre Channel
device, perform the following tasks:
Verify that all of the Fibre Channel devices were turned on before you turned
1.
on the Content Engine.
Ensure that all cables are connected properly.
2.
Verify that you configured your RAID storage subsystems using the utilities
3.
provided by the manufacturer.
If your Fibre Channel switch supports zoning, make sure that your peripheral
4.
device is configured to the same switch zone as the Fibre Channel adapter.
Cisco Content Engine 511 and 566 Hardware Installation Guide
Installing Adapters
-xxii.)
4-11
Advertisement
Table of Contents
Troubleshooting
