Optical Bypass Module Specifications; Fan Assembly - Cisco SCE8000 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for SCE8000:
- Configuration manual (262 pages) ,
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages)
Table of Contents
Advertisement
Chapter 2
Introduction to the Cisco SCE8000 Platform
Optical Bypass Module Specifications
Fiber Cable Type
The fiber cable type within the Optical Bypass Module area as follows:
•
•
Maximum optical path (fiber length of two ports) is 600m.
Switching Time
Switching time is measured from trigger to stable 90% optical output.
•
•
Fan Assembly
The system fan assembly, located in the chassis, provides cooling air for the installed modules. Sensors
on the fan assembly and within the system monitor the internal air temperatures. If the air temperature
exceeds a preset threshold, the environmental monitor displays warning messages.
Figure 2-9
Fan Assembly
SCE 8000
-SC M-E
FA N
ST AT U
S
SCE 8000
-SC M-E
SCE 8000
Captive installation screws
If an individual fan within the assembly fails, the FAN STATUS LED turns red. To replace a fan
assembly, see
OL-16478-03
OPB-SCE8K-MM: 50 um core.
OPB-SCE8K-SM: SMF-28
Typical switching time: 3 ms
Maximal switching time: 10ms
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
STA TUS
LINK
1000
OP TIC AL
ACT IVE
BY PAS S
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
STA TUS
LINK
1000
OP TIC AL
ACT IVE
BY PAS S
-SIP
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
TX
TX
TX
A C
RX
TX
CT RL
B
RX
D
A B
RX
C
RX
D
ST AT US
OP TIC AL
BY PA SS
OP B- SC
1
E8 K- MM
Removing and Replacing the Fan Assembly, page
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
9-11.
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
The Cisco SCE8000 Optical Bypass
2-11
Advertisement
Table of Contents
Troubleshooting
