Spa Installation And Removal; Installing A Spa In A Sip - Cisco SCE8000 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for SCE8000:
- Configuration manual (262 pages) ,
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages)
Table of Contents
Advertisement
Chapter 9
Removal and Replacement Procedures
SPA Installation and Removal
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
SPAs can be inserted or removed independently from the SIP. Removal of a SIP with installed SPAs is
also supported.
Figure 9-17
Figure 9-17
This number...
1
2
Installing a SPA in a SIP
To install a SPA in a SIP, refer to
At the SCE# prompt, type reload shutdown and press Enter to power down the Cisco SCE8000
Step 1
platform before installing or removing any module.
To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at
Step 2
the top left and top right of the SPA slot and are recessed about an inch, as shown in
Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface
Step 3
connector. When fully seated, the SPA might be slightly behind the SIP faceplate.
After the SPA is properly seated, fasten the SPA in place with the captive installation screws.
Step 4
OL-16478-03
illustrates how to install and remove a SPA in the SCE8000-SIP.
SPA Installation and Removal
76 00 -S
IP -40 0
SP A INT
ER FA CE
PR OC
ES SO R
SP A- 1X
10G E-L
-V2
SP A- 1X
10G E-L
-V2
2
1
Indicates this component
SCE8000-SIP
1X10GBE SPA module
Figure 9-17
and do the following:
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
Removing and Replacing Shared Port Adapters
Figure
9-17.
9-25
Advertisement
Table of Contents
Troubleshooting
