Miscellaneous Settings - Cisco FM3200 Base Installation And Configuration Manual

Hide thumbs Also See for FM3200 Base:

Table of Contents

6.6.13. Miscellaneous settings

IMPORTANT

Support for FIPS, CANBUS, PROFINET and QNET are only

available if the corresponding plug-ins are installed. If the

corresponding plug-in is not installed, the check-box for the

relevant option will not be available.

The following plug-ins are needed to activate these features:

Note that FIPS support is not available for the FM1000

Gateway and FM10000 Gateway.

Contact your Cisco Networks representative for details.

The MISC SETTINGS window contains controls to change the following

settings:

• The device name, as used to identify the Cisco FM3200 Base within

the FMQuadro network map and to other Cisco utilities.

• The operation of the physical Reset button on the unit.

• Device firmware upgrades by trivial file transfer protocol (TFTP).

• The unit's federal information processing standards (FIPS) 140-2

compliance settings (if applicable).

• The unit's controller area network (CANBUS) support settings (if

applicable).

• The unit's process field net (PROFINET) support settings (if

applicable).

• The unit's Neutrino Qnet (QNET) support settings (if applicable).

To change any of the miscellaneous settings, do the following steps:

Click the -misc settings link under ADVANCED SETTINGS in

the left-hand settings menu.

• The MISC SETTINGS dialog will be shown

(page

Device configuration using the configurator interface

• FIPS: FM-FIPS

• CANBUS: FM-CANBUS

• PROFINET: FM-PROFINET

• QNET: FM-QNET

123)).

(Figure 52

Page 122 of 176

Table of Contents