Table of Contents
Advertisement
7.6.13. Miscellaneous settings
IMPORTANT
Support for FIPS, CANBUS, PROFINET and QNET are only
available if the corresponding plug-ins are installed. If the
corresponding plug-in is not installed, the check-box for the
relevant option will not be available.
The following plug-ins are needed to activate these features:
Note that FIPS support is not available for the FM1000
Gateway and FM10000 Gateway.
Contact your Cisco Networks representative for details.
The MISC SETTINGS window contains controls to change the following
settings:
• The device name, as used to identify the Cisco FM4200 Fiber within
the FM Quadro network map and to other Cisco utilities.
• The operation of the physical Reset button on the unit.
• Device firmware upgrades by trivial file transfer protocol (TFTP).
• The unit's federal information processing standards (FIPS) 140-2
compliance settings (if applicable).
• The unit's controller area network (CANBUS) support settings (if
applicable).
• The unit's process field net (PROFINET) support settings (if
applicable).
• The unit's Neutrino Qnet (QNET) support settings (if applicable).
To change any of the miscellaneous settings, do the following steps:
1.
Click the -misc settings link under ADVANCED SETTINGS in
the left-hand settings menu.
• The MISC SETTINGS dialog will be shown
(page
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
• FIPS: FM-FIPS
• CANBUS: FM-CANBUS
• PROFINET: FM-PROFINET
• QNET: FM-QNET
138)).
(Figure 52
Page 137 of 189
Advertisement
Table of Contents
