Table of Contents
Advertisement
3.3. Cisco Network Addressing
3.3.1. Bridge IP addressing
If needed, the Cisco FM4200 Fiber can be operated in Bridge mode. This
creates a single point-to-point connection between two network segments.
A simplified example of a Bridge mode connection is shown in
(page
22).
As shipped from the factory, the wired ethernet ports of all Cisco
hardware components are assigned the same default IP address of
192.168.0.10/24.
No default IP address is associated with the wireless interface.
Figure 4. Wireless network architecture (bridge configuration)
3.3.2. Unit identification and addressing
Mesh- and bridge-capable radio transceiver identification
CAUTION
This section contains theoretical explanations of the underlying
concepts behind mesh network addressing, and is intended for
use by qualified network engineers only.
Regardless of its configuration and operating mode, every Cisco
radio transceiver is shipped from the factory with a unique unit
identification (ID) number. This number always takes the following form:
© 2021 Cisco and/or its affiliates. All rights reserved.
• For specific instructions on Cisco hardware
installation, see
"Hardware installation" (page
• For specific instructions on how to configure a
Cisco radio transceiver unit using the configurator
interface,
see
"Device
configurator interface" (page
Getting Started
Figure 4
30).
configuration
using
the
55).
Page 22 of 189
Advertisement
Table of Contents
