Troubleshooting; I Cannot Get The Log-In Screen; I Cannot Log In To The Fm Racer Interface; I Forgot The Administrator Password - Cisco FM3200 Base Installation And Configuration Manual
Hide thumbs
Also See for FM3200 Base:
- Installation and configuration manual (189 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and configuration manual (179 pages)
Table of Contents
Advertisement
8. Troubleshooting
This section contains information that will allow you to solve common
problems associated with configuration and installation of Cisco
products.
8.1. I cannot get the Log-in screen
If you have directly connected a Windows computer to your Cisco
device for device configuration, but you cannot access the log-in form on
your web browser, check the following points:
Are you trying to access the unit using a valid IP address?
You must manually set the computer's IP address and Netmask to be
recognizable by the Cisco device. The correct settings are as follows:
• IP address: 192.168.0.10 (or any other IP address belonging to
subnet 192.168.0.0/255.255.255.0)
• Netmask: 255.255.255.0
Have you disabled the 'Access the Internet using a proxy server' function?
If your browser shows a time-out or similar message, the computer may
be trying to access the Cisco device through a proxy server. To stopthe
computer from trying to access the unit through a proxy connection,
refer to
"Accessing the Cisco FM3200 Base for device configuration"
(page
42).
8.2. I cannot log in to the FM Racer interface
IMPORTANT
For a detailed description of the differences between the FM
Racer configuration interface and the local Configurator
interface, refer to
interface" (page
If you are not able to log in to the FM Racer web-based configuration
interface, check that you have entered the correct user name and
password.
The factory-set user name for the FM Racer configuration interface is
admin. The factory-set password is admin
To change the factory-set user name and
the Cisco Networks FM Racer User Manual.
8.3. I forgot the Administrator password
If you have forgotten the Administrator user name and/or password for the
Configurator interface, and you must access the unit to configure it using
the Configurator interface, do the following steps:
© 2021 Cisco and/or its affiliates. All rights reserved.
"Device configuration using the configurator
40).
Troubleshooting
password,
refer
to
Page 155 of 176
Advertisement
Table of Contents
