Fm Racer; Point-To-Point Wireless Bridge - Cisco FM3200 Base Installation And Configuration Manual

Hide thumbs Also See for FM3200 Base:

Table of Contents

Note that Prodigy 2.0 is only compatible with device firmware versions 6.5

and higher.

IMPORTANT

Prodigy 1.0 and Prodigy 2.0 are not compatible with each

other. Do not implement the two protocol versions within the

same network.

If you are expanding an existing network using new Cisco

hardware components, make sure that all components are

compatible with each other by:

Use of Prodigy 1.0 is only recommended if the network

contains older Cisco devices that are not compatible with

Prodigy 2.0.

Select the Prodigy version you need by using the General

Mode page of the Configurator interface.

FM Racer

RACER™ is Cisco's web-based configuration portal. It is the primary

interface with which to configure Cisco radio devices.

You can operate FM Racer using any internet-connected computer with a

web browser.

IMPORTANT

For a detailed description of the differences between FM Racer

and the local Configurator interface, refer to

configuration using the configurator interface" (page

A point-to-point wireless bridge allows two local networks to communicate

with each other. A simplified example is shown in

In context of the overall network architecture, the two local networks are

called network segments.

1. Upgrading all network components within the same

network to firmware version 6.5 or higher, and:

2. Configuring all network components within the same

network to operate using either Prodigy 1.0 or Prodigy

2.0.

Getting Started

"Device

40).

Figure 1 (page

17).

Page 16 of 176

Table of Contents