Rules For Packet Management - Cisco FM3200 Base Installation And Configuration Manual

Hide thumbs Also See for FM3200 Base:

Table of Contents

Figure 50. Configurator GUI (VLAN SETTINGS dialog)

Connect the unit to a VLAN that is part of the local wireless

network by checking the Enable VLANs check-box.

Check the

Enter the management identification number of the VLAN (used

to communicate with the device's operating system) in the

Management VLAN ID: field.

Enter the native identification number (the VLAN ID implicitly

assigned to untagged packets received on trunk ports) in the

Native VLAN ID: field.

Save the VLAN settings by clicking the Save button. Alternatively,

clear the settings by clicking the Reset button.

Rules for packet management

Parameter

Default VLAN configuration

The factory-set VLAN parameters for the unit are as follows:

Management VLAN ID (MVID)

Native VLAN ID (NVID)

Native VLAN processing

Port mode (all Ethernet ports)

Traffic classes

The system classifies incoming data packets according to the following definitions:

Signaling

User

Device configuration using the configurator interface

Enable VLANs check-box.

NOTE

The same Management VLAN ID must be used on all

Cisco devices that are part of the same mesh

network.

Enabled

Smart

Ethernet protocol type $8847 or $09xx

All other traffic

Default value

Page 116 of 176

Table of Contents