Using The Bandwidth Test Tool - Cisco FM3200 Base Installation And Configuration Manual
Hide thumbs
Also See for FM3200 Base:
- Installation and configuration manual (189 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and configuration manual (179 pages)
Table of Contents
Advertisement
Figure 31. Advanced Tools window (Ping test tool)
3.
Click the
• The ping test result will be shown below the test controls.
Using the Bandwidth Test tool
The Bandwidth test can be run with the network under load (to test
operational performance), or with the network unloaded (to test installed
capacity). The test tool generates a stream of packets at a rate of 4
Mbits/sec to test available network path throughput.
IMPORTANT
Bandwidth rate computation is CPU-intensive, and must be
regarded as indicative only. Note that bandwidth testing tends
to underestimate the actual link throughput.
To use the Bandwidth test tool, do the following steps:
1.
Determine what wireless link is to be tested between the
Cisco unit and another unit in the wireless network. Get theIP
address of the other unit.
2.
Enter the IP address of the other unit in the Bandwith test
(4Mbit/s UDP): field
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Run button to the right of the IP address field.
(Figure 32 (page
87)).
Page 86 of 176
Advertisement
Table of Contents
