Reactivating A Deactivated Plug-In - Cisco FM3200 Base Installation And Configuration Manual
Hide thumbs
Also See for FM3200 Base:
- Installation and configuration manual (189 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and configuration manual (179 pages)
Table of Contents
Advertisement
• The plug-in will be deactivated.
• The Deactivation code will be shown in the Deactivation
Code column of the plug-in listing.
• The Deactivation code will remain on the Partner Portal,
and can be used to generate a new Activation code if
needed.
7.2.3. Reactivating a deactivated plug-in
To use a Deactivation code to generate an new Activation code, do the
following steps:
1.
Log on to the
2.
Click the
• The Plug-ins web page will be shown
151)).
Figure 73. Partner Portal (Plug-ins web page)
3.
Check the selection check-box to the left of the relevant plug-in
listing.
• The plug-in control buttons will be shown at the bottom of
the web page.
4.
Enter the unit identification number (5.a.b.c) or the unit serial
number of the Cisco unit in the Mesh ID - Serial Number
field.
© 2021 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
Only click the Force Deactivation button if you have
no way to retrieve the deactivation code (for
example, if the unit's boot sequence cannot be
completed, or if the unit is damaged and cannot be
powered ON).
Cisco Partner
Portal.
Plug-ins link.
Software Plug-Ins
(Figure 73 (page
Page 151 of 176
Advertisement
Table of Contents
