Ssh Access - Cisco 8961 Administration Manual
Unified communications manager 10.0 sip
Hide thumbs
Also See for 8961:
- Administration manual (292 pages) ,
- User manual (180 pages) ,
- Features (35 pages)
Table of Contents
Advertisement
SSH Access
Field
Allow EnergyWise
Overrides
SSH Access
You can enable or disable access to the SSH daemon through port 22. Leaving port 22 open leaves the phone
vulnerable to Denial of Service (DoS) attacks. By default, the SSH daemon is disabled.
Phones that are upgraded from Firmware Release 9.2.0 or earlier to Firmware Release 9.2.1 or later have
Note
the SSH Access parameter set to Disabled by default. You must enable the SSH Access parameter before
users of these phones can use SSH.
The following table describes the SSH Access field.
• Common Phone Profile Configuration (Device > Device Settings > Common Phone Profile).
• Phone Configuration (Device > Phone windows).
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
222
REVIEW DRAFT - CISCO CONFIDENTIAL
Description
This check box determines whether you allow the EnergyWise domain controller
policy to send power level updates to the phones. The following conditions
apply:
1 One or more days must be selected in the Enable Power Save Plus field.
2 The settings in Cisco Unified Communications Manager Administration take
effect on schedule even if EnergyWise sends an override.
For example, assuming the Phone Off Time is set to 22:00 (10:00 p.m.), the
value in the Phone On Time field is 06:00 (6:00 a.m.), and the Enable Power
Save Plus has one or more days selected.
• If EnergyWise directs the phone to turn off at 20:00 (8:00 p.m.), that
directive remains in effect (assuming no phone user intervention occurs)
until the configured Phone On Time at 6:00 a.m.
• At 6:00 a.m., the phone turns on and resumes receiving the power level
changes from the settings in Unified Communications Manager
Administration.
• To change the power level on the phone again, EnergyWise must reissue
a new power level change command.
Note
To disable Power Save Plus, you must uncheck the Allow EnergyWise
Overrides check box checked. Leaving the Allow EnergyWise Overrides
checked with no days selected in the Enable Power Save Plus field does
not disable Power Save Plus.
Cisco Unified IP Phone Customization
- Quick Links:
- Cisco Unified Ip Phone 8961, 9951,...
Hide quick links:
Advertisement
Chapters
Table of Contents
