Table of Contents
Advertisement
NTP- D257 Change the PM Display
NTP-D257 Change the PM Display
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Complete the
are already logged in, continue with Step 2.
Step 2
In node view, double-click the electrical, Ethernet, optical (STM-N), multirate transport, or dense
wavelength division multiplexing (DWDM) card where you want to view PM counts. The card view
appears.
As needed, use the following tasks to change the display of PM counts:
Step 3
•
•
•
•
•
•
•
•
•
•
•
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
8-2
This procedure changes the display of PM counts by selecting
drop-down list or radio button options in the Performance window.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and Low-Order Tunnels"
As needed
Onsite or remote
Retrieve or higher
"DLP-D60 Log into CTC" task on page 17-49
DLP-D124 Refresh PM Counts at 15-Minute Intervals, page 18-23
DLP-D125 Refresh PM Counts at One-Day Intervals, page 18-23
DLP-D259 Refresh Ethernet PM Counts at a Different Time Interval, page 19-63
DLP-D126 View Near-End PM Counts, page 18-24
DLP-D127 View Far-End PM Counts, page 18-25
DLP-D458 Monitor PM Counts for a Selected Signal, page 21-34
DLP-D129 Reset Current PM Counts, page 18-25
DLP-D459 Clear Selected PM Counts, page 21-36
DLP-D457 Refresh E-Series and G-Series Ethernet PM Counts, page 21-33
DLP-D260 Set Auto-Refresh Interval for Displayed PM Counts, page 19-64
DLP-D261 Refresh PM Counts for a Different Port, page 19-65
Chapter 8
Chapter 6, "Create Circuits
and
Chapter 10, "Change Card Settings."
at the node that you want to monitor. If you
Monitor Performance
78-17194-01
Advertisement
Chapters
Table of Contents
