Table of Contents
Advertisement
Chapter 6
Create Circuits and Low-Order Tunnels
NTP-D323 Create an Automatically Routed High-Order Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
where you will create the circuit. If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
automatically based on circuit type, node name, and sequence number, continue with
Step 3
If you are creating a circuit on G-Series cards, complete the
Ports" task on page 19-21
If you are creating a circuit on ML-Series, CE-100T-8 or CE-1000-4 circuits, complete the following as
Step 4
necessary (you can provision Ethernet or packet-over-SDH (POS) ports before or after the VCAT circuit
is created):
•
•
•
•
•
Step 5
From the View menu, choose Go to Network View.
Step 6
Click the Circuits tab, then click Create.
In the Circuit Creation dialog box, complete the following fields:
Step 7
•
•
•
Click Next.
Step 8
78-17194-01
This procedure creates an automatically routed bidirectional or
unidirectional high-order circuit, including VC4 and concatenated
VC4-2c, VC4-3c, VC4-4c, VC4-8c, VC4-16c, and VC4-64c speeds.
None
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D314 Assign a Name to a Port" task on page
before or after you create the G-Series circuit.
To provision Ethernet ports for CE-100T-8 circuits, complete the
Ethernet Ports" task on page
To provision Ethernet ports for CE-1000-4 circuits, complete the
Ethernet Ports" task on page
To provision POS ports for CE-100T-8 or CE-1000-4 circuits, complete the
CE-100T-8 and CE-1000-4 POS Ports" task on page
To provision Ethernet ports for ML-Series circuits, complete the
Port of the ML-Series Card" task on page
To provision POS ports for ML-Series circuits, complete the
the ML-Series Card" task on page
Circuit Type—Choose VC_HO_PATH_CIRCUIT.
Number of Circuits—Enter the number of high-order circuits that you want to create. The default
is 1. If you are creating multiple circuits with the same source and destination, you can use
auto-ranging to create the circuits automatically.
Auto-ranged—This check box is automatically selected when you enter more than 1 in the Number
of Circuits field. Leave this check box selected if you are creating multiple high-order circuits with
the same source and destination and you want CTC to create the circuits automatically. Uncheck the
box if you do not want CTC to create the circuits automatically.
NTP- D323 Create an Automatically Routed High-Order Circuit
18-30.
19-8.
18-33.
21-49.
21-50.
Cisco ONS 15454 SDH Procedure Guide, R7.0
at an ONS 15454 SDH on the network
Step
2.
20-7. If you want CTC to assign a name
Step
"DLP-D222 Provision G-Series Ethernet
"DLP-D136 Provision CE-100T-8
"DLP-D211 Provision CE-1000-4
"DLP-D141 Provision
"DLP-D493 Provision the Ethernet
"DLP-D494 Provision the POS Port of
5.
6-55
Advertisement
Chapters
Table of Contents
