Mdl - Cisco ASR 9000 Series Command Reference Manual
Aggregation services router
Hide thumbs
Also See for ASR 9000 Series:
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages) ,
- Configuration manuallines (694 pages)
Table of Contents
Advertisement
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
mdl
To configure the Maintenance Data Link (MDL) message defined in the ANSI T1.107a-1990 specification,
use the mdl command in T3 configuration mode. To remove the message, use the no form of this command.
{mdl string {eic| fi| fic| gen-number| lic| port-number| unit} string| transmit {idle-signal| path| test-signal}
{disable| enable}}
{no mdl string {eic| fi| fic| gen-number| lic| port-number| unit} string| transmit {idle-signal| path|
test-signal} {disable| enable}}
Syntax Description
string eic string
string fi string
string fic string
string gen-number string
string lic string
string port-number string
string unit string
transmit idle-signal
transmit path
transmit test-signal
disable | enable
Command Default
No MDL message is configured.
Command Modes
T3 configuration
Command History
Release
Release 3.9.0
Specifies the Equipment Identification Code; can be up to 10 characters.
Specifies the Facility Identification Code sent in the MDL Path message;
can be up to 38 characters.
Specifies the Frame Identification Code; can be up to 10 characters.
Specifies the Generator number string sent in the MDL Test Signal
message; can be up to 38 characters.
Specifies the Location Identification Code; can be up to 11 characters.
Specifies the Port number string sent in the MDL Idle Signal message;
can be up to 10 characters.
Specifies the Unit Identification Code; can be up to 6 characters.
Specifies the transmission of the MDL Idle Signal message.
Specifies the transmission of the MDL Path message.
Specifies the transmission of the MDL Test Signal message.
Disables or enables transmission of the specified message.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Modification
This command was introduced.
mdl
Release 5.3.x
1027
Hide quick links:
Advertisement
Table of Contents
