Adjustments Required When The Belt Loop Length Is Changed; Adjusting Fork Bracket F - Brother BAS-705 Instruction Manual

Instruction manual - english

Hide thumbs Also See for BAS-705:

Table of Contents

6-1. Adjustments required when the belt loop length is changed

Carry out the following adjustments after changing the length of the belt loop.

needle hole

6. STANDARD ADJUSTMENT (MECHANISMS)

Retract slider base F e so that loop presser

NOTE

F q does not touch the fork shaft w.

Refer to "6-1-2 Adjusting slider base F" on

page 50".

1. Loosen the two bolts r, and then move fork bracket

F t in the direction of the arrow so that it matches

the width between the machine needles, and then

tighten the two bolts r.

NOTE: It will be easier to see the position relative to

the needle hole at this time if the air is released

and the fork shaft y is lowered so that it is

below the presser foot u.

The diameter of the fork shaft, the loop thick-

ness and the amount of looseness will all have

slight effects on the bar tacking position, so

carry out a test sewing to check the position.

2. Loosen the two screws !0 and move the loosen loop

presser plate i as far as possible (approx 0.5 mm)

so that it does not touch the presser foot u and so

that it is parallel to the loosen loop presser set plate

BAS-705

Table of Contents

Show Quick Links

Table of Contents