Table of Contents
Advertisement
6. STANDARD ADJUSTMENT (MECHANISMS)
6-1-2. Adjusting slider base F
q
w
!1
!2
r
t
e
y
o
i
!2
6-1-3. Adjusting the height of the slider bracket
e
!0
!1
u
w
q
r
1. Loosen the two bolts q, move slider base F w so
that it is aligned with fork bracket F e, and then
tighten the bolts q.
NOTE: Check that loosen loop presser plate B r and
loosen loop presser plate F t do not touch
loop presser UB y or loop presser UF u when
the air has been released and the fork bracket
is moved to about the middle of loop presser
F i and loop presser B o.
If the upper guide plate !0 gets in the way,
remove the two bolts !1 and then remove the
upper guide plate !0 .
Refer to "6-1-5 Adjusting the upper guide
plates" on page 50 for details on the upper
guide plate.
2. Loosen the two bolts ! 1 , move the loop hold plate
! 2 in between loop presser F i and loop presser B
o, and then tighten the bolt !1 .
1. Release the air, loosen the bolt q, and then move
the cylinder stopper w up by the amount of drop.
After adjusting, tighten the bolt q.
NOTE: Raise the slider bracket as high as possible
while ensuring that the belt loops do not go
under the loop pressers B e F r.
50
BAS-705
- Quick Links:
- Part Names1
- Error Codes
Hide quick links:
Advertisement
Table of Contents
