Table of Contents
Advertisement
3. PANEL OPERATION
3-2-7. Setting the X scale and Y scale
This procedure is used to set the enlargement and reduction ratios for the sewing pattern in
the X direction and Y direction.
The setting ranges for both the X scale and Y scale are between 45% - 150%. However,because
the size of the pattern will be checked against the sewing area, it may not be possible to set
the scale to the maximum setting in this range.
w
AUTO MODE
2nd bobbin counter
Speed
Loop length
ADJUSTMENT(/)
Loop/feed
X-Y/program
X-Y/test feed
X-Y/PROGRAM/(ADJ)
Program No.
X scale (%)
Y scale (%)
X-Y/PROGRAM/(ADJ)
Program No.
X scale (%)
Y scale (%)
X-Y/PROGRAM/(ADJ)
Program No.
X scale (%)
Y scale (%)
MODE
SELECT
e
z//
zz/
WARNING
CANCEL
ENTER
t
1. Press the MODE switch w to select AUTO mode.
2. While pressing the
MODE switch w.
* This will change the mode to ADJUSTMENT
mode.
SELECT switches e to move the
3. Use the
and
pointer " " so that "X-Y/program" is selected, and
then press the ENTER switch t.
4. Use the
and
move the pointer "
is selected.
5. While using the
cursor "-" , press the
to set the scale setting.
* If the CANCEL switch r is pressed, the
old previously-set scale ratio will appear again
on the display.
6. Press the ENTER switch t.
* The new scale ratio setting for the X scale or Y
scale will appear on the display.
* At this time, the feed mechanism will return to
the sewing home position.
20
POWER
RESET
r
SELECT switch e, press the
SELECT switches e again to
" so that "X scale" or "Y scale"
SELECT switch eto move the
and SELECT switches e
BAS-705
- Quick Links:
- Part Names1
- Error Codes
Hide quick links:
Advertisement
Table of Contents
