Connecting The System Ground - Cisco SCE8000 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for SCE8000:
- Configuration manual (262 pages) ,
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages)
Table of Contents
Advertisement
Connecting the System Ground
Remove the module filler plate covering the subslot in the mounting panel by loosening the two screws.
Step 2
Carefully insert the optical bypass module into the subslot (there are no guide rails) and tighten the
Step 3
captive screws on either side of the module.
Figure 4-15
Connecting the System Ground
This section describes how to connect a system (earth) ground to the Cisco SCE8000 chassis.
You must connect the system ground on both AC- and DC-powered systems to an earth ground if this
Note
equipment is installed in a US or European Central Office.
For DC-powered systems, the system ground is also the power supply ground. The DC ground must be
Note
installed with a permanent connection to an earth ground according to NEC guidelines.
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
4-18
Optical Bypass Modules in External Mounting Panel
FA N ST
SCE 8000
-SCM -E
AT US
SC M
1
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
STA TUS
LINK
1000
OPT ICA
ACTI VE
L BYP ASS
SCE 8000
-SCM -E
SC M
2
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
STA TUS
LINK
1000
OPT ICA
ACTI VE
L BYP ASS
SCE 8000
-SIP
SIP
3
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
4
SC E8 00
0- FA N
Chapter 4
Installing the Cisco SCE8000 Chassis
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MOD ULE
MA STE R
SYS TEM
POW ER
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
OL-16478-03
Advertisement
Table of Contents
Troubleshooting
