Boot Sequence; Supplying Power To The Cisco Fm3200 Base - Cisco FM3200 Base Installation And Configuration Manual

Hide thumbs Also See for FM3200 Base:

Table of Contents

Figure 6. Status and link/boot LEDs

During normal operation, the seven LEDs indicate the following

conditions:

• Power: The Cisco FM3200 Base is receiving power.

• LAN1: Network activity on Ethernet port 1.

• LAN2: Network activity on Ethernet port 2.

• SIGNAL STRENGTH (red): Signal strength very poor.

• SIGNAL STRENGTH (yellow): Signal strength inadequate.

• SIGNAL STRENGTH (green): Signal strength acceptable.

• SIGNAL STRENGTH (green): Signal strength excellent.

TIP

During normal operation, the readings from the four SIGNAL

STRENGTH LEDs can be used to do radio antenna alignment

(see

64)

Boot sequence

During the unit's boot sequence, the four SIGNAL STRENGTH LEDs light

up in sequence. During the boot sequence, the LEDs indicate the

following conditions:

1. Red: Core system boot in progress.

2. Yellow: Wireless system boot in progress.

3. First green: Routing engine boot in progress.

4. Second green: Unit configuration boot in progress.

If the boot sequence above stops at any LED, an error has been detected

during that stage of the boot sequence.

CAUTION

When connecting the Cisco FM3200 Base to a power supply,

be sure to follow the instructions in this section at all times.

Failure to follow these instructions may result in irreparable

damage to the unit and/or other connected hardware, and will

also invalidate the product warranty.

"Antenna-alignment tools and physical statistics" (page

for more information).

Hardware installation

Page 25 of 176

Table of Contents