Table of Contents
Advertisement
(8)Removing the Feed Motor Unit
1) Remove the rear cover. (See 1.A.(3).)
2) Open the harness retainer [1], and disconnect the two connectors [2].
3) Remove the screw [3], and detach the harness guide [4].
4) Remove the three screws [5], and detach the feed motor unit [6].
[5]
[4]
[1]
Fig.F03-102-35
(9)Removing the Feed Roller
1) Remove the upper cover. (See 1.A.(4).)
2) Remove the upper right cover assembly. (See 1.A.(6).)
3) Remove the feed motor unit. (See 1.B.(6).)
4) Remove the screw [1].
5) Remove the stop ring [2], and detach the bushing [3].
[1] [3]
[2]
Fig.F03-102-36
6) Remove the two screws [4].
Fig.F03-102-37
[5]
[3]
[6]
[2]
[4]
AR-FN7/PN1 DISASSEMBLY AND ASSEMBLY 5-9
7) Remove the gear [5], and detach the gear [6] while spreading the claw.
8) Remove the stop ring [7], and detach the bushing [8].
9) Remove the screw [9], and detach the inlet sensor [10].
10) Remove the lower paper guide [11].
Fig.F03-102-38
11) Remove the feed roller [12].
Fig.F03-102-39
(10)Removing the Stack delivery roller (upper)
1) Remove the paddle assembly. (See 1.B.(4).)
2) Place the paddle assembly [1] as shown.
Fig.F03-102-40
3) Turn the gear [2] in the direction of the arrow to move up the stack
delivery roller assembly (upper) [3].
[3]
Fig.F03-102-41
[5]
[8]
[9]
[10]
[6]
[7]
[11]
[12]
[1]
[2]
Advertisement
Table of Contents
Troubleshooting
