Table of Contents
Advertisement
<3> Remove the lock release lever that has been attached to the front
cabinet.
Reattach the front cabinet to its original position, push in the staple
unit, and attach it using the two screws.
Insert the protrusion (B) of the lock release lever that has been
removed before to the hole (C) of the latch arm.
After attaching it, move the lever to check that it moves smoothly.
If the lever does not move smoothly, remove the lock release lever
by releasing the pawl at the lower part of the lock release lever using
a flat-blade screwdriver or the like and then insert it again.
Staple unit
Screws
Front cabinet
<4> Reattach the jam handling dial and close the front cover.
Jam handling dial
8) Reattach the front cover to the right front of the finisher.
<1> Attach the front cover using the screws A and B (two for each).
Front cover
Screws B
Screws A
9) Paste the dust box label to the top cover.
<1> Paste the supplied dust box label to the location indicated in the
Pawl (D)
Latch arm
10) Connect the connector to the stand/paper drawer and connect the
(C)
<1> Connect the connector of the relay harness of the finisher to the
Lock release lever (A)
Projection (B)
11) Paste the label.
<1> Paste the label to the position shown in the illustration.
AR-FN7/PN1 UNPACKING AND INSTALLATION 3-6
illustration.
AC cord of the power supply unit to the main unit of the printer.
stand/paper drawer and tighten the screws of the connector.
Screws
Connector
(Paste it only if the scanner module is installed.)
AC cord
Advertisement
Table of Contents
Troubleshooting
