Table of Contents
Advertisement
(1)Inlet Sensor Delay Jam (1011)
The inlet sensor does not detect paper approximately 1.5 sec after the host machine generates the delivery signal.
Jam check
Inlet sensor (ES)
Feed motor (FFM)
(2)Inlet Sensor Stationary Jam (1021)
The paper does not leave the inlet sensor approximately 2 sec after the inlet sensor has detected its leading edge.
Jam check
Inlet sensor (ES)
Feed motor (FFM)
(3)Folding Position Sensor Delay Jam (1012)
In bind mode, the folding position sensor does not detect paper 1200 msec after the intermediate processing tray starts to send paper to the stapling
position.
Jam check
Folding position
sensor (FPS)
Delivery motor (FAM)
(4)Folding Position Sensor Stationary Jam (1022)
In bind mode, paper does not leave the holding position sensor approximately 10.5 sec after the staple/fold motor is driven.
Jam check
Folding position
sensor (FPS)
Staple/fold
motor (FFSM)
(5)Power-On Jam (1007)
Paper is detected inside the finisher at power-on or when the door is closed.
(6)Door Open Jam (paper present) (1008)
The finisher is disconnected from its host machine or the front door, or the upper cover is opened while the system is in operation (paper on the move).
(7)Staple Jam (1006)
The staple home position sensor (STHPS) does not go OFF 600 msec after the stapler is driven. Or, it does not return to its home position (where the
sensor goes ON).
Host machine delivery signal
approx. 1.5sec.
Normal
approx. 2sec.
Normal
1200 ms
Normal
approx. 10.5sec.
Normal
AR-FN7/PN1 OPERATIONAL DESCRIPTION 4-17
Host machine delivery signal
approx. 1.5sec.
Jam check
Inlet sensor (ES)
Feed motor (FFM)
Fig.F02-701-02
Jam check
Inlet sensor (ES)
Feed motor (FFM)
Fig.F02-701-03
Jam check
Folding position
sensor (FPS)
Delivery motor (FAM)
Fig.F02-701-04
Jam check
Folding position
sensor (FPS)
Staple/fold
motor (FFSM)
Fig.F02-701-05
Jam
approx. 2sec.
Jam
1200 ms
Jam
approx. 10.5sec.
Jam
Advertisement
Table of Contents
Troubleshooting
