Table of Contents
Advertisement
2. AR-PN1
<Before installation>
For installation of AR-PN1A/PN1B/PN1C/PN1D, a saddle stitch finisher
(AR-FN7) must have been installed.
Parts included
Harness A (purple): 1 pc.
Screw
(M4 x 6 with rosette)
Dust box label:
: 1 pc.
1 sheet
1) Turn off the main switch of the main unit of the printer.
<1> Turn the main switch located on the front side of the main unit to the
"OFF" position.
"OFF"
<2> Then remove the power plug of the main unit from the outlet.
<3> Loosen the screw and remove the connector of the finisher.
Harness B (orange): 1 pc.
Hole punch position label:
2 sheets
Screws
Connector
AR-FN7/PN1 UNPACKING AND INSTALLATION 3-4
2) Remove the front cover from the right front of the finisher.
<1> Remove the screws A and B (two for each) that secure the finisher
front cover and remove the front cover.
Front cover
Screws B
Screws A
3) Remove the front cabinet and the rear cabinet from the finisher.
<1> Open the front door of the finisher and remove the jam handling dial.
Jam handling dial
<2> Remove the two front cabinet securing screws, pull out the staple
unit until it stops, then remove the pawl of the front cabinet in the
direction indicated by the arrow and remove the front cabinet.
<3> Remove the three screws that fix the rear cabinet and remove the
rear cabinet.
At this time, remove the relay harness through the opening of the
rear cabinet.
Pawl
Staple unit
Screws
Front cabinet
<3> Remove the three rear cabinet securing screws, remove the pawl in
the direction indicated by the arrow, and remove the rear cabinet.
At this time, remove the relay harness through the opening of the
rear cabinet.
Screw
Pawl
Rear
cabinet
Screw
Opening for
relay harness
Relay harness
Advertisement
Table of Contents
Troubleshooting
