Table of Contents
Advertisement
If it is not inserted smoothly, use the following procedure to adjust the height.
a. If the guide pin of the lock securing plate is not aligned with the
connecting hole of the finisher:
<1> Loosen the screw at the rear adjusting portion.
<2> Remove the cap using a flat-blade screwdriver or the like and adjust
the height adjusting pin so that the guide pin is positioned to the
center of the connecting hole of the finisher.
<3> Loosen the screw at the front adjusting portion.
Front side
Screw at
adjusting
portion
Height adjusting
screw
Screw at adjusting portion
<4> Adjust the height adjusting pin so that the exterior lines are aligned
as shown in the illustration.
Exterior lines
Front cover
Exterior lines
<5> If the guide pin can be inserted smoothly, tighten the screws at the
front and rear adjusting portions and mount the caps.
b. If the guide pin of the locking plate matches to the connecting
hole of the finisher:
<1> Push the finisher into the main unit.
<2> If the gap between the main unit of the printer and the finisher is not
uniform at the top and the bottom, remove the caps from the front
side and the rear side of the finisher stand using a flat-blade
screwdriver or the like and remove the screw of the sub covers on
the front side and the rear side to remove the sub covers.
<3> Then, loosen the four screws at the adjusting portions indicated in
the illustration and turn the height adjusting screws on the front side
and the rear side so that the gap becomes uniform.
Finisher stand
Cap
Cap
Height
adjusting
screw
Rear side
Gap
Gap
AR-FN7/PN1 UNPACKING AND INSTALLATION 3-3
<4> If the gap becomes uniform, tighten the screws at the adjusting
portions and reattach the caps and sub covers.
Cap
Height
Sub cover
Rear side
Screw
Screw at adjusting portion
Screw
9) Paste the stapling position labels.
<1> Paste the labels to the positions shown in the illustration.
10) Remove the AC inlet cover from the rear cabinet of the stand/paper
drawer.
<1> Remove the screw that fixes the AC inlet cover and then remove the
AC inlet cover.
Screw
11) Connect the finisher connector.
<1> Connect the finisher connector to the stand/paper drawer.
<2> Tighten the screw of the connector.
Screw
Connector
12) Turn on the main switch of the main unit.
<1> Insert the power plug of the main unit to the outlet.
<2> Turn on the main switch of the main unit.
Cap
adjusting screw
Sub cover
Front side
Screw at adjusting portion
AC inlet cover
"ON"
Advertisement
Table of Contents
Troubleshooting
