Table of Contents
Advertisement
Operation, Display and Application Examples
LED display
P7-04
running
parameters 2
When the AC drive is powered on again after power failure, the parameters that are selected
before power failure are displayed.
Set the values of the parameters by referring to the following example.
Determine the parameters to be displayed. Running frequency, Bus voltage, Output voltage,
Output current, Output frequency, Output torque, PID feedback, Encoder feedback speed
Set the binary data.
P7-03: 0000 0000 0111 1101B, P7-04: 0010 0000 0000 0001B
Convert the binary data to hexadecimal data:
P7-03: 007DH, P7-04: 2001H
The values displayed on the operation panel are respectively H.1043 and H.2001 respectively
for P7-03 and P7-04.
3.6 Starting or Stopping the AC Drive
3.6.1 Selecting the Start/Stop Command Source
There are three start/stop command sources, namely, operation panel control, terminal control,
and communication control. You can select the command source in P0-02.
Function Code
Parameter Name
Command
P0-02
source selection
Bit00: PID feedback
Bit01: PLC stage
Bit02: Pulse setting
frequency (kHz)
Bit03: Running frequency2
Bit04: Remaining running
time
Bit05: AI1 voltage before
correction
Bit06: AI2 voltage before
correction
Bit07: AI3 voltage before
correction
Setting Range
0: Operation panel
control (indicator OFF)
1: Terminal control
(indicator ON)
2: Communication control
(indicator blinking)
20
PE6000 User Manual
Bit08: Linear speed
Bit09: Current power-on
time (Hour)
Bit10: Current running
time (Minute)
Bit11: Pulse setting
frequency (Hz)
Bit12: Communication
setting value
Bit13: Encoder feedback
speed (Hz)
Bit14: Main frequency X
display (Hz)
Bit15: Auxiliary
frequency Y display (Hz)
Description
Press Run or Stop to start
or stop the AC drive.
A DI terminal needs to be
defined as the run/stop
terminal.
The Modbus-RTU
communication protocol is
used.
☆
0
Hide quick links:
Advertisement
Table of Contents
