Advertisement
4.2.6 E592, Punch sensor (waste full) Fault (detail code: 06)
Waste full Sensor (waste full photosensor PCB/waste full LED PCB)
Wiring
Punch controller PCB, Finisher controller PCB
4.2.7 E593, Horizontal Registration Motor Fault (detail code: 01/02)
Horizontal registration home position sensor (PI2P)
Wiring
Horizontal registration mechanism, horizontal registration motor (M2P)
Punch controller PCB, Finisher controller PCB
COPYRIGHT © 2001 CANON INC.
Chap05.p65
1) Check the waste full sensor. Is the sensor normal?
NO:
Replace the sensor.
2) Is the wiring between the punch controller PCB and the waste full
sensor normal?
NO:
Correct the wiring.
3) Try replacing the punch controller PCB. Is the problem corrected?
YES: End.
NO:
Replace the finisher controller PCB.
T05-402-06
1) Check the horizontal registration home position sensor. Is the sen-
sor normal?
NO:
Replace the sensor.
2) Is the wiring between the finisher controller PCB and the horizon-
tal registration home position sensor normal?
NO:
Correct the wiring.
3) Is there a fault in the horizontal registration mechanism?
YES: Correct the horizontal registration mechanism.
NO:
Replace the horizontal registration motor.
4) Try replacing the punch controller PCB. Is the problem corrected?
YES: End.
NO:
Replace the finisher controller PCB.
T05-402-07
2000 2000 2000 2000
CANON SADDLE FINISHER G1 REV.0 MAR. 2001
27
CHAPTER 5 TROUBLESHOOTING
3/28/01, 12:11 PM
5-27
Advertisement
