Advertisement
CHAPTER 5 TROUBLESHOOTING
4.1.3 E510, Feed Motor Fault (detail code: 01/02)
Stack feed roller (upper) home position sensor (PI12)
1) Check the stack feed roller (upper) home position sensor. Is it nor-
mal?
NO:
Wiring
2) Is the wiring between the finisher controller PCB and the feed mo-
tor normal?
NO:
Feed roller
3) Try turning the stack feed roller (upper) shaft by hand. Does the
stack feed roller (upper) move up/down normally?
NO:
Feed motor (M1), Finisher controller PCB
4) Try replacing the feed motor. Is the problem corrected?
YES: End.
NO:
4.1.4 E514, Delivery Motor Fault (detail code: 01/02)
Delivery belt home position sensor (PI7)
1) Check the delivery belt home position sensor. Is the sensor normal?
NO:
Wiring
2) Is the wiring between the finisher controller PCB and the delivery
motor normal?
NO:
Stack delivery roller
3) Try turning the stack delivery roller by hand. Is the rotation
smooth?
NO:
Delivery motor (M3), Finisher controller PCB
4) Try replacing the delivery motor. Is the problem corrected?
YES: End.
NO:
5-18
COPYRIGHT © 2001 CANON INC.
Chap05.p65
Replace the sensor.
Correct the wiring.
Correct the mechanical system.
Replace the finisher controller PCB.
T05-401-03
Replace the sensor.
Correct the wiring.
Correct the mechanical system.
Replace the finisher controller PCB.
T05-401-04
2000 2000 2000 2000
18
CANON SADDLE FINISHER G1 REV.0 MAR. 2001
3/28/01, 12:11 PM
Advertisement
