Ip Routev6 Command; Adjust Bfd Interval; Enable Advertising Bgp Routes From Standby Icsr Chassis; Saving The Configuration - Cisco ASR 5000 Administration Manual
Staros release 21.1
Hide thumbs
Also See for ASR 5000:
- Installation manual (294 pages) ,
- Administration manual (159 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
BFD Support for Link Aggregation Member Links
ip routev6 Command
configure
context context_name
ipv6 route ipv6_address/prefix_length { interface name | next-hop ipv6_address interface name } [ cost
cost] [ fall-over bfd multihop mhsess_name ] [ precedence precedence ] [ vrf vrf_name [ cost value
] [ fall-over bfd multihop mhsess_name ] [ precedence precedence ]
end
The ipv6 route command now also allows you to add a static multihop BFD route.
ipv6 route static multihop bfd mhbfd_sess_name local_endpt_ipv6addr remote_endpt_ipv6addr
Adjust BFD Interval
Set the transmit interval (in milliseconds) between BFD packets to meet the convergence requirements of
your network deployment.
configure
context context_name
interface interface_name broadcast
Notes:
• milliseconds is an integer from 50 through 10000. (Default 50)
Enable Advertising BGP Routes from Standby ICSR Chassis
For information on configuring the feature, see
page
Saving the Configuration
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
BFD Support for Link Aggregation Member Links
Member-link based BFD detects individual link failures faster than LACP and reduces the overall session/traffic
down period as a result of single member link failure.
ASR 5000 System Administration Guide, StarOS Release 21.1
276
bfd interval interval_num min_rx milliseconds multiplier value
end
265.
Advertising BGP Routes from a Standby ICSR Chassis , on
Routing
Advertisement
Table of Contents
Troubleshooting
