Configuring Bgp; Redistributing Routes Into Bgp (Optional) - Cisco ASR 5000 Administration Manual
Staros release 21.1
Hide thumbs
Also See for ASR 5000:
- Installation manual (294 pages) ,
- Administration manual (159 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
Configuring BGP
• Route Filtering for inbound and outbound routes
• Route redistribution and route-maps
• Support for BGP communities and extended communities in route maps
• Local preference for IPv4 and IPv6 (IBGP peers)
IP pool routes and loopback routes are advertised in the BGP domain in the following ways:
• Through BGP Configuration Mode redistribution commands, all or some of the connected routes are
• Through the BGP Configuration Mode network commands, connected routes are explicitly configured
Important
Configuring BGP
This section describes how to configure and enable basic BGP routing support in the system.
config
context context_name
Notes:
• A maximum of 64 BGP peers are supported per context.
• Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Redistributing Routes Into BGP (Optional)
Redistributing routes into BGP simply means that any routes from another protocol that meet a specified
criterion, such as a route type, or a rule within a route-map, are redistributed through the BGP protocol to all
BGP areas. This is an optional configuration.
config
context context_name
[ route-map route_map_name ]
Notes:
ASR 5000 System Administration Guide, StarOS Release 21.1
262
redistributed into the BGP domain. (IP pool and loopback routes are present in the IP routing table as
connected routes.) The network routemap command provides the flexibility to change many BGP
attributes.
for advertisement into the BGP domain. The network routemap command provides the flexibility to
change many BGP attributes. Refer to the BGP Configuration Mode Commands chapter of the Command
Line Interface Reference for details on these commands.
If a BGP task restarts because of a processing card failure, a migration, a crash, or the removal of a
processing card, all peering session and route information is lost.
router bgp AS_number
neighbor ip_address remote-as AS_num
router bgp as_number
redistribute bgp { bgp | connected | static } [ metric metric_value ] [ metric-type { 1 | 2 } ]
Routing
Advertisement
Table of Contents
Troubleshooting
